1. When using the new drill pipe, it should be determined that the custom hdd fly cutter reamers front cut (protection shaft head) wire is also new, a bad custom hdd fly cutter reamers is easy to damage the new drill pipe wire, resulting in water leakage, buckle, loose and other conditions

2. When using the drill pipe for drilling, it should be "grinding the new buckle" first, which includes first applying the thread oil, then tightening with the rig, then opening the buckle, and then applying the thread oil to open it again, so repeated three times, you can avoid the wear and tear of the new rod and the buckle.

3. Keep the drill pipe as straight as possible under the ground and above the ground. This prevents the side of the thread from being stressed and causing unwanted wear or even skipping.

4. The buckle should be tightened slowly to reduce overheating wear.

5. Each time the buckle must be tightened with full torque, and often pay attention to whether the condition of the clip is good.

6. Shorten the distance from the drill to the ground entrance, because if the drill pipe lacks support, it will be easy to bend and deform when the drill pipe is propelled and guided, resulting in shorter life.

7. Keep the inlet Angle as small as possible and slowly change the Angle according to the drill pipe safety requirements.

8. Do not exceed the maximum bending radius of the drill pipe, pay special attention to the change of the Angle of the horizontal section when drilling and the change of the Angle when drilling out.

9. Keep the use of drill pipe in turn, avoid fixing the use of fixed drill pipe to guide and pull back, must take turns, so as to avoid excessive wear and break the rod.

custom hdd fly cutter reamers https://www.uniquehdd.com/fly-cutter-reamer.html