Be careful with the operation and use of laser cutting equipment

At present, many laser cutting equipment are used in many industries. However, because such equipment is very accurate, it should be noted that technical training is required before operation, and there are many points needing attention in daily use. You must remember the maintenance of the equipment. We will explain the key points to pay attention to when using laser cutting equipment.

First of all, when using the laser cutting system, you must pay attention to many operation and maintenance matters, and you must replace the cooling water according to the requirements of the facility. In many cases, you must replace it in January, and you must replace it every three months. In particular, considering the frequency of use, it should be noted that the cooling water must be replaced and replaced with new cooling water. If the facility has a designated brand of cooling water, the designated brand of water must be used. If it is not emphasized, the blockage of the cooling water equipment will become serious.

Second, when using laser cutting equipment, oxygen should be in contact with high-pressure liquid oxygen, and vaporizers must be added, and the gas condition should be very important. Therefore, liquid oxygen can be raised to normal temperature gas, the pressure of oxygen pipe should be 4.5MPa, and the oxygen purity should not exceed 99.6%. Similarly, attention must be paid to nitrogen and air conditions.

Thirdly, when oxygen enters the pipe of replacing the air cylinder of the workbench, sparks occur during the operation of the equipment, the air duct is burned, and the air pressure in the driving cylinder is not less than 1MPa. Otherwise, the gas pipe will be unable to withstand the pressure and explode.

The first thing I want to say is that you must be careful when using or cutting laser cutting equipment. In addition, since there are many types of laser cutting devices, it is necessary to understand these problems according to specific models. This ensures the normal operation of the laser cutting machine, reduces the failure rate and extends the life of the equipment.。